Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1
- Perform an inspection of the A/F sensor and PCM-related connectors and wiring harnesses.
Step 2
- Perform a unit inspection of the A/F sensor.
Repair completion verification
- Verify that the primary malfunction is resolved and there are no other malfunctions.

P0131-00: (PCM - VIN Y) TROUBLESHOOTING DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: INSPECT WIRING HARNESS (INCLUDING CONNECTOR/TERMINAL) BETWEEN A/F SENSOR AND PCM FOR MALFUNCTION Inspect the applicable circuit. (see CIRCUIT INSPECTION .) (see CONNECTOR INSPECTION .) Is the circuit normal?	Yes	Go to the next step.
1		No	Repair or replace the malfunctioning location and perform the repair completion verification 1.
2	PURPOSE: DETERMINE INTEGRITY OF A/F SENSOR Start the engine and warm it up completely. Display the PCM PID [A/F_SEN_CUR] using the M-MDS. Drive the vehicle under the following conditions. WARNING: While performing this step, always operate the vehicle in a safe and lawful manner. When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later. After increasing the engine speed to 3, 000 rpm, decelerate using engine braking. Is the displayed PID value as follows? A/F_SEN_CUR: 0.25 mA or more	Yes	Go to the next step.
2		No	Replace the A/F sensor and perform the repair completion verification 1. (Refer to AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION (VIN Y) in service information.)
Repair completion verification 1	PURPOSE: VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (see CLEARING DTC .) Replicate the vehicle conditions at the time the DTC was detected using the following procedure. Implement the repeatability verification procedure. (See REPEATABILITY VERIFICATION PROCEDURE .) Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the PCM, then go to the next step. (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y) in the service information.)
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	PURPOSE: VERIFY IF OTHER DTCs DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification 2		No	DTC troubleshooting completed.