LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (On-Board Diagnostic - Engine Control (VIN Y) (6 Of 6)) >> DTC U2300-00: Global Central Configuration Error >> Function Inspection Using M-MDS

Function Inspection Using M-MDS

WARNING: This page is about a different variant/trim than selected.
U2300:00 (PCM - VIN Y) FUNCTION INSPECTION USING M-MDS

Step Inspection Results Action
1 PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY 
  • Verify related Service Bulletins, on-line repair information, or Service Information availability.
  • Is any related Information available?
 Yes Perform repair or diagnosis according to the available information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION 
  • Record the freeze frame data/snapshot data.
    NOTE:
    • Recording can be facilitated using the screen capture function of the PC.
 - Go to the next step.
3 PURPOSE: INSPECT FOR OTHER RELATED DTCs 
  • Perform the DTC inspection for the PCM.

    (See DTC INSPECTION .)

  • Are other DTCs displayed?

    PCM 

    • U0140:00
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See U0140-00: .)
Go to the next step.
No Go to the next step.
4 PURPOSE: VERIFY BODY CONTROL MODULE (BCM) DTCs 
  • Perform the DTC inspection for the body control module (BCM). (See DTC INSPECTION .)
  • Is a DTC displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See DTC TABLE [BCM] .)
Go to the troubleshooting procedure to perform the procedure from Step 1.
No Go to the troubleshooting procedure to perform the procedure from Step 1.
scientia non olet · About LEMON Manuals