LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transaxle (Service Information) - GW6AX-El) >> M Position Switch Inspection [GW6AX-El] >> Continuity Inspection

Continuity Inspection

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The M position switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
    2. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    3. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
    4. Cup holder (See CUP HOLDER REMOVAL/INSTALLATION .)
    5. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    6. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .)
    7. Rear console bracket No. 1 (See REAR CONSOLE REMOVAL/INSTALLATION .)
  3. Disconnect the selector lever component connector.
    G16374939Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals B and H.
    G16374940Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals