LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transaxle (Service Information) - GW6AX-El) >> Drive Plate Removal/Installation [GW6AX-El] >> Notes

Drive Plate Removal/Installation [GW6AX-El]: Notes

WARNING: This page is about a different variant/trim than selected.

Special Service Tool (SST) 

49 E011 1A0
Ring gear brake set
G16374935Courtesy of MAZDA MOTORS CORP.

Replacement Part 

Bolt
Quantity: 8
Location of use: Drive plate
  1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL] .)
  2. Remove in the order indicated in the table.
    Fig 1: Drive Plate With Torque Specification (GW6AX-EL)
    G16374936Courtesy of MAZDA MOTORS CORP.
    DRIVE PLATE COMPONENT OPERATION

    Component no Refer to
    1 Drive plate installation bolts
    (See DRIVE PLATE INSTALLATION BOLTS REMOVAL NOTE .)
    (See DRIVE PLATE INSTALLATION BOLTS INSTALLATION NOTE .)
    2 Backing plate
    3 Drive plate
  3. Install in the reverse order of removal.