LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transaxle (Service Information) - GW6AX-El) >> Drive Plate Removal/Installation [GW6AX-El] >> Drive Plate Installation Bolts Removal Note

Drive Plate Installation Bolts Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Set the SST against the drive plate.
    Fig 1: Drive Plate Installation Bolts Loosening Sequence
    G16374937Courtesy of MAZDA MOTORS CORP.
  2. Loosen the drive plate installation bolts uniformly in two or three steps in the order shown in the figure, then remove the bolts and the drive plate.
scientia non olet · About LEMON Manuals