LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> MX-5 Miata RF Club >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service Information)) >> Down Switch Inspection >> Continuity Inspection >> Notes

Continuity Inspection: Notes

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The down position switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
    2. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION .)
  3. Disconnect the selector lever component connector.
    G14589341Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals D and H.
    G14589342Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals