Horn LO
- Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Front under cover (See FRONT UNDER COVER REMOVAL/INSTALLATION .)
- Seal plate (RH) (See SEAL PLATE REMOVAL/INSTALLATION .)
- Horn LO (See HORN REMOVAL/INSTALLATION .)
- Connect the battery voltage to horn LO terminal A, and connect the ground to the horn LO retaining bolt.
- Verify that the horn LO sounds.
- If the horn LO does not sound, replace the horn LO. (See HORN REMOVAL/INSTALLATION .)