LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 Turbo Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (On-Board Diagnostic - Engine Control System (VIN M) (1 Of 7)) >> DTC P00FE-00: Evaporator System-Clogging Between Fuel Tank And Fuel Tank Pressure Sensor >> PID Item/Simulation Item Used In Diagnosis >> Simulation item table

Simulation item table

WARNING: This page is about a different variant/trim than selected.
SIMULATION PART DESCRIPTION

Item Applicable component Operation Operation condition
Engine condition Other condition
EVAPCP Purge solenoid valve Changes % and forcibly drives/stops purge solenoid valve.
  • Under the following conditions:
    • Ignition is switched ON (engine off)
    • Idle (no load)
 Not applicable
EVAPCV CV solenoid valve Select OFF/ON to forcibly drive/stop the CV solenoid valve.
  • Under the following conditions:
    • Ignition is switched ON (engine off)
    • Idle (no load)
CAUTION:
  • Do not add fuel with the CV solenoid valve closed. Otherwise, it will result in air pollution because the evaporative gas in the fuel tank will escape directly into the atmosphere.
NOTE:
  • Override drive parameter: Off
    • CV solenoid valve: open
    • Override drive parameter: On
    • CV solenoid valve: close
scientia non olet · About LEMON Manuals