Details On DTCs

WARNING: This page is about a different variant/trim than selected.

DTC P00FE-00: (PCM, VIN M) DETECTION CONDITION AND POSSIBLE CAUSE

DESCRIPTION	Evaporator system: clogging between fuel tank and fuel tank pressure sensor
DETECTION CONDITION	Determination conditions	The following conditions are all met while the vehicle is being driven: If negative pressure is inducted to the fuel tank via the intake manifold by the operation of the purge solenoid valve with the fuel tank in a sealed condition and the target negative pressure is reached within a shorter period of time than the estimated time. When the barometric pressure in the fuel tank is fixed and the purge solenoid valve is opened/closed, the negative pressure fluctuation in the fuel tank generates negative pressure exceeding the threshold.
	Preconditions	Evaporative gas flow amount: Exceeds 10, 000 cm³ /min or fuel tank vacuum is high Fuel tank pressure: -4, 340.2-4, 030.1 Pa {-442.57-410.95 kgf/m² , -0.62949-0.58452 psi}^1 IAT sensor No. 1: 4.44-43.33 °C {40.0-109.9 °F}^1 Vehicle speed: 64-145 km/h {40.0-90.0 mph}^1 Barometric pressure: above 72.23 kPa {0.7365 kgf/cm² , 10.48 psi}^1 Period ignition is switched off before engine starts: 210 min or more Fuel level in fuel tank: 15-85 %^1 Minimum value of intake manifold vacuum: 4 kPa {0.04 kgf/cm² , 0.6 psi} or more Minimum value of intake air amount: above 2 g/sec Battery voltage: above 11 V^1 The following DTCs are not detected: ECT sensor: P0117-00:, P0118-00: TP sensor No. 1: P0122-00:, P0123-00: TP sensor No. 2: P0222-00:, P0223-00: Purge solenoid valve: P0443-00: CV solenoid valve: P0446-00: MAF sensor: P0100-00: Fuel tank pressure sensor: P0451-00:, P0452-00:, P0453-00: IAT sensor No. 1: P0110-00: MAP sensor: P0069-00:, P0107-00:, P0108-00: BARO sensor: P2226-00:, P2228-00:, P2229-00: VSS signal: P0500-00: Fuel gauge sender unit: P0460-00:, P0461-00:, P0462-00:, P0463-00: ^*1 : Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	75 s period
	Drive cycle
	Self test type	CMDTC self test
	Sensor used	Fuel tank pressure sensor
FAIL-SAFE FUNCTION	Not applicable
VEHICLE STATUS WHEN DTCs ARE OUTPUT	Illuminates check engine light.
POSSIBLE CAUSE	Erratic signal to PCM Fuel tank pressure sensor signal malfunction Fuel gauge sender unit malfunction Fuel tank pressure sensor malfunction Clogging between fuel tank and fuel tank pressure sensor Fuel shut-off valve malfunction Rollover valve malfunction Purge solenoid valve malfunction PCM malfunction