Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1
- Perform inspection of coolant control valve.
Step 2-3
- Verify that the primary malfunction is resolved and there are no other malfunctions.

TROUBLESHOOTING DIAGNOSTIC PROCEDURE

STEP	INSPECTION	RESULTS	ACTION
1	INSPECT COOLANT CONTROL VALVE Inspect the coolant control valve. (See COOLANT CONTROL VALVE INSPECTION [VIN M] ). Is there any malfunction?	Yes	Replace the coolant control valve, then go to the next step. (See COOLANT CONTROL VALVE REMOVAL/INSTALLATION [VIN M] ).
1		No	Go to the next step.
2	PURPOSE: VERIFICATION OF VEHICLE REPAIR COMPLETION Always reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC ). Implement the repeatability verification procedure. (See Repeatability Verification Procedure ). Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST ). Is the PENDING CODE for this DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [VIN M] ). Go to the next step.
2		No	Go to the next step.
3	PURPOSE: VERIFY IF THERE IS ANY OTHER MALFUNCTION Is any other DTC or pending code stored?	Yes	Go to the applicable DTC inspection. (See DTC TABLE ).
3		No	DTC troubleshooting completed.