LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly >> No. 3 Engine Mount >> Notes

No. 3 Engine Mount: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Slots have been adopted for the No. 3 engine mount installation holes. If the No. 3 engine mount is deviated from the original position when installing the No. 3 engine mount, engine noise or vibration could increase. Before removing the No. 3 engine mount, place alignment marks on the No. 3 engine mount and body so that they can be assembled to the same positions as before removal.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION ).
  3. Remove in the order indicated in the table. 4. Install in the reverse order of removal.
    Fig 1: No. 3 Engine Mount Components With Torque Specification
    G13671661Courtesy of MAZDA MOTORS CORP.
    PART SPECIFICATION

    1 No. 3 engine mount
    (See No. 3 engine mount removal note ).
    (See No. 3 engine mount installation note  ).
scientia non olet · About LEMON Manuals