LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly >> No. 3 Engine Mount >> No. 3 engine mount removal note

No. 3 engine mount removal note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the clip and bolt shown in the figure and set the ground cable aside.
    G13107124Courtesy of MAZDA MOTORS CORP.
  2. Set the PCM component aside using the following procedure:
    1. Remove the bolts and connector shown in the figure.
      G13107125Courtesy of MAZDA MOTORS CORP.
    2. Move the PCM component in the direction of the arrow shown in the figure and set it aside with the PCM connectors connected.
      G13107126Courtesy of MAZDA MOTORS CORP.
  3. Disconnect the clip shown in the figure.
    G11436639Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolts and nut shown in the figure and remove the wiring harness bracket.
    G13107128Courtesy of MAZDA MOTORS CORP.
  5. Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION ).
    CAUTION:
    • To prevent deformation of the oil pan, support the engine using the following methods.
      • When using an engine lifter, insert rubber of appropriate size (approx. 20 mm {0.79 in} thickness) between the engine lifter and the oil pan to support the oil pan.
      • When using a garage jack, place rubber of appropriate size (approx. 20 mm {0.79 in} thickness) on a batten which is large enough to cover and support the oil pan.
  6. Before removing the No. 3 engine mount, support the engine (oil pan) using a commercially available engine lifter or garage jack.
    G11436642Courtesy of MAZDA MOTORS CORP.
  7. Place alignment marks on the locations shown in the figure so that they can be assembled to the same positions as before removal.
    G11436643Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Paint so that the No. 3 engine mount is framed on the body side and the outline of the nut is framed on the No. 3 engine mount side.
  8. Remove the No. 3 engine mount.
scientia non olet · About LEMON Manuals