No. 1 Engine Mount (AWD): Notes

WARNING: This page is about a different variant/trim than selected.

When removing the No. 1 engine mount bracket B for AWD vehicles, perform the procedure with the transfer completely removed from the transaxle.

Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION ).
Remove in the order indicated in the table.

Install in the reverse order of removal.

Fig 1: No. 1 Engine Mount Components With Torque Specification (AWD)

Courtesy of MAZDA MOTORS CORP.

PART SPECIFICATION

1	No. 1 engine mount bracket A (See No. 1 engine mount removal note (AWD) ). (See No. 1 engine mount installation note (AWD) ).
2	No. 1 engine mount rubber (See No. 1 engine mount removal note (AWD) ). (See No. 1 engine mount installation note (AWD) ).
3	No. 1 engine mount bracket B (See No. 1 engine mount removal note (AWD) ). (See No. 1 engine mount installation note (AWD) ).