Exhaust System Removal/Installation (2WD): Notes
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
- Remove in the order indicated in the table.
- Remove the insulator. (See Exhaust System Insulator Removal/Installation (2WD) ).
- Install in the reverse order of removal.
Step 1
PART SPECIFICATION
| 1 | Main silencer |
| 2 | Plate (See Plate installation note (2WD) ). |
| 3 | Brace bar (See Brace bar removal note (2WD) ). (See Brace bar installation note (2WD) ). |
| 4 | Tunnel member (See Tunnel member installation note (2WD) ). |
| 5 | HO2S (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION ). |
| 6 | TWC |
Step 2
PART SPECIFICATION
| 1 | Insulator (See Insulator removal note (2WD) ). (See Insulator installation note (2WD) ). |
| 2 | A/F sensor (See AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION ). |
| 3 | WU-TWC insulator No. 1 (See WU-TWC insulator No. 1 installation note (2WD) ). |
| 4 | WU-TWC (See WU-TWC installation note (2WD) ). |
| 5 | WU-TWC insulator No. 2 |
| 6 | Dynamic pressure turbo (See DYNAMIC PRESSURE TURBO REMOVAL/INSTALLATION ). |
| 7 | Exhaust manifold (See Exhaust manifold installation note (2WD) ). |