LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-9 Sport, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Intake-Air System And Turbocharger >> Intake-Air System Removal/Installation >> Charge Air Cooler Inlet Hose Installation Note

Charge Air Cooler Inlet Hose Installation Note

  1. Clean the seal surface and furrow area of the charge air cooler air inlet pipe and turbocharger air outlet pipe.
    G11436419Courtesy of MAZDA MOTORS CORP.
  2. Degrease the seal surface of the pipe, and verify if there is foreign matter penetration or scratches.
    • If there is foreign matter penetration or scratches, replace the pipe.
  3. Apply engine oil to the seal surface of the pipe.
    NOTE:
    • Make sure that the installation direction of the charge air cooler hose is correct and verify the marking shown in the figures.
    G11436420Courtesy of MAZDA MOTORS CORP.
  4. Align the pipe rib and connector groove positions, and install.
    G11436421Courtesy of MAZDA MOTORS CORP.
  5. Insert the pipe connector completely into the connector.
    G11436422Courtesy of MAZDA MOTORS CORP.
  6. Pull the pipe outward and verify that a click sound is heard.
    G11436423Courtesy of MAZDA MOTORS CORP.
  7. Install the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
  8. Install the front under cover No. 1. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals