Function Inspection Using M-MDS

WARNING: This page is about a different variant/trim than selected.

DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

STEP	INSPECTION	RESULTS	ACTION
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: RECORD FREEZE FRAME DATA/SNAPSHOT DATA AND DIAGNOSTIC MONITORING TEST RESULTS TO UTILIZE WITH REPEATABILITY VERIFICATION Recording can be facilitated using the screen capture function of the PC. Record the FREEZE FRAME DATA/snapshot data and DIAGNOSTIC MONITORING TEST RESULTS (EVAP system related) on the repair order.	-	Go to the next step.
3	PURPOSE: VERIFY FUEL FILLER CAP MALFUNCTION Access the FCL PID using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST .) Is the FCL PID value On? completely closed. Is the fuel-filler cap completely closed?	Yes	Go to the Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
3		No	Go to the Troubleshooting Diagnostic Procedure to perform the procedure from Step 2.
2	PURPOSE: DETERMINE INTEGRITY OF FUEL FILLER CAP Inspect the fuel filler cap. Is there any malfunction?	Yes	Replace the fuel filler cap, then go to the next step. (See FUEL-FILLER PIPE REMOVAL/INSTALLATION [VIN Y] .)
2		No	Go to the next step.
3	PURPOSE: VERIFICATION OF VEHICLE REPAIR COMPLETION Reconnect all the removed parts. Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .) Implement the repeatability verification procedure. (See Repeatability Verification Procedure .) Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1 of the troubleshooting diagnostic procedure. If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [VIN Y] .) Go to the next step.
3		No	Go to the next step.
4	PURPOSE: VERIFY IF THERE IS ANY OTHER MALFUNCTION Is any other DTC or pending code stored?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
4		No	DTC troubleshooting completed.