Repeatability Verification Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION:

When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later.

While performing this step, always operate the vehicle in a safe and lawful manner.
1. Start the engine and warm it up until the engine coolant temperature exceeds 80 °C {176 °F}.
2. Start the engine, race it at 4, 000 rpm, and idle it.
3. Repeat Step 2 operation above 2 times.