LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transaxle System (Service Information) (GW6A-El, GW6AX-El)) >> Up Switch Inspection >> Continuity Inspection

Continuity Inspection

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The up switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
    2. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
    3. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION .)
    4. Cup holder (See CUP HOLDER REMOVAL/INSTALLATION .)
    5. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    6. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
    7. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    8. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .)
  3. Disconnect the selector lever component connector.
    G11429134Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals C and H.
    G11279349Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals