LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Cup Holder Removal/Installation

Cup Holder Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the console side panel. (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
  3. Remove the switch panel. (See SWITCH PANEL REMOVAL/INSTALLATION .)
  4. Open the console lid and remove the storage box.
    G11427856Courtesy of MAZDA MOTORS CORP.
  5. Insert the remover tools into the service holes.
    G11427857Courtesy of MAZDA MOTORS CORP.
  6. Move the remover tools in the direction of the arrows shown in the figure and detach the clips from the rear console.
    G11427858Courtesy of MAZDA MOTORS CORP.
  7. Move the cup holder in the order of arrows (1) and (2) shown in the figure, and remove it while detaching the clips and hooks.
    G11427859Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals