Coil Resistance Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
Disconnect the OCV connector.
Measure the resistance between terminals A and B using an ohmmeter.

Courtesy of MAZDA MOTORS CORP.

OCV coil resistance

6.9-7.55 ohms [20°C {68°F}]
- If not as specified, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
Install in the reverse order of removal.