Slow Engaging After Operating Selector Lever From N To D Position: Notes
WARNING: This page is about a different variant/trim than selected.
SLOW ENGAGING AFTER OPERATING SELECTOR LEVER FROM N TO D POSITION (ET6A-EL, ET6AX-EL) DESCRIPTION AND POSSIBLE CAUSE
| Troubleshooting item |
Slow engaging after operating selector lever from N to D position |
| Description |
- Slow engagement when depressing the accelerator pedal just after operating the selector lever from N to D position with the ATF temperature at 60 °C {140 °F} or more.
- Malfunction symptom only occurs once when accelerating from a standstill.
- Engagement after operating the selector lever from N to R position is normal.
- Engagement when shifting gears while driving is normal.
- DTCs are not stored.
|
| Possible cause |
- Insufficient TCM learning (Insufficient learning in N to D position)
- Low clutch piston malfunction
- Low clutch hydraulic system sealing malfunction
|
| System wiring diagram |
|
| Connector diagram |
|