Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

ENGINE STALLS WHEN SHIFTED TO D, M OR R POSITION (ET6A-EL, ET6AX-EL, US) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT ENGINE SYSTEM OR AUTOMATIC TRANSAXLE OPERATION FOR MALFUNCTION Perform the symptom troubleshooting "ENGINE STALLS-AFTER START/AT IDLE" and "LOW IDLE/STALLS DURING DECELERATION". (See ENGINE STALLS-AFTER START/AT IDLE [(VINs 7, L)] .) (See LOW IDLE/STALLS DURING DECELERATION [VIN 7, VIN L) (US)] .) Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
1		No	Go to the next step.
2	DETERMINE IF MALFUNCTION IS DUE TO TORQUE CONVERTER OPERATION MALFUNCTION Verify the malfunction symptom. Does the engine stall in the R position?	Yes	Replace the torque converter. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (VIN 7, VIN L) (US)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (VIN 7, VIN L) (US)] .)
2		No	Go to the next step.
3	DETERMINE IF MALFUNCTION IS DUE TO TCC SOLENOID VALVE OPERATION MALFUNCTION OR AUTOMATIC TRANSAXLE INTERNAL MALFUNCTION Verify the malfunction symptom. Does the engine stall in the D or M position?	Yes	Replace the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION .)
3		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (VIN 7, VIN L)) (US)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (VIN 7, VIN L) (US)] .)