Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

ENGINE FLARES UP OR SLIPS WHEN UPSHIFTING OR DOWNSHIFTING (ET6A-EL, ET6AX-EL, US) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY MALFUNCTION SYMPTOM Is the malfunction symptom at the same level compared to a vehicle of the same model (ET6A-EL, ET6AX-EL vehicles)?	Yes	Symptom troubleshooting is completed.
1		No	Go to the next step.
2	PERFORM INITIAL LEARNING Perform the initial learning. (See INITIAL LEARNING .) Does the symptom disappear?	Yes	Symptom troubleshooting is completed.
2		No	Go to the next step.
3	INSPECT SIGNAL PARTS FOR MALFUNCTION Inspect the value at the following PCM PIDs using the M-MDS. (See PID/DATA MONITOR INSPECTION .) APP1 (APP sensor No. 1) APP2 (APP sensor No. 2) MAF (MAF sensor) ENG_RPM (CKP sensor) Is there any malfunction? (See PID/DATA MONITOR TABLE [PCM (VIN 7, VIN L) (US)] .)	Yes	Repair or replace any malfunctioning parts according to the inspection result.
3		No	Symptom troubleshooting is completed.