Diagnostic Procedure

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

DTC B00A0:07 (AIRBAG) (US) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC .) Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION .) Is the DTC B1193:00, B00C0:93, B00C1:93, B00C2:93 or B00C3:93 displayed?	Yes	If DTC B1193:00 is displayed: Inspect the front passenger seat frame and seat rail for distortion and deformation. Replace the malfunctioning part and perform the repair completion verification. If DTC B00C0:93, B00C1:93, B00C2:93 or B00C3:93 is displayed: Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (AIRBAG) (US) .)
1		No	Go to the next step.
2	VERIFY IF PASSENGER-SIDE FRONT SEAT IS INSTALLED CORRECTLY Verify the passenger-side front seat installation condition. (See FRONT SEAT REMOVAL/INSTALLATION (US) .) Is the installation condition normal?	Yes	Go to the next step.
2		No	Correctly install the passenger-side front seat and perform the repair completion verification. (See FRONT SEAT REMOVAL/INSTALLATION (US) .)
3	VERIFY IF SEAT WEIGHT SENSOR IS INSTALLED CORRECTLY Verify the seat weight sensor installation condition. (See SEAT WEIGHT SENSOR REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .) Is the installation condition normal?	Yes	Go to the next step.
3		No	Correctly install the seat weight sensor and perform the repair completion verification. (See SEAT WEIGHT SENSOR REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
4	PERFORM DTC INSPECTION Clear DTCs using the M-MDS. (See CLEARING DTC .) Verify DTCs using the M-MDS. (See DTC INSPECTION .) Are the same Pending DTCs present?	Yes	Replace the suspect seat weight sensor control module and perform the repair completion verification. (See SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
4		No	DTC troubleshooting completed.
Repair completion verification	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC .) Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION .) Are the same Pending DTCs present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
Repair completion verification		No	DTC troubleshooting completed.