Jack up procedure for rear wheel (AWD)

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For AWD vehicles, set the jack to the jack up position of the side sill so that a rear wheel can be jacked up. When the jack cannot be set to the jack up position of the rear differential, refer to the jack up procedure (2WD) for the rear wheel and jack up a rear wheel. (See JACK UP PROCEDURE FOR REAR WHEEL (2WD)) )

Set the wheel blocks to the front and back of the front wheels.
Set the jack to the jack up position of the rear differential shown in the illustration and jack up a rear wheel.

Courtesy of MAZDA MOTORS CORP.
Install the safety stand (rigid rack) to the safety stand (rigid rack) installation position of the rear wheel shown in the illustration.

Courtesy of MAZDA MOTORS CORP.