LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (General Information) >> Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions >> Jacking up Using Garage Jack >> Jack up procedure for rear wheel (2WD)

Jack up procedure for rear wheel (2WD)

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the wheel blocks to the front and back of the front wheels.
  2. Set the jack to the jack up position of the side sill on the right side shown in the illustration and jack up the right rear wheel.
    G13556026Courtesy of MAZDA MOTORS CORP.
  3. Install the safety stand (rigid rack) to the safety stand (rigid rack) installation position for the right rear wheel shown in the illustration.
    G13556027Courtesy of MAZDA MOTORS CORP.
  4. Set the jack to the jack up position of the side sill on the left side and jack up the left rear wheel.
  5. Install the safety stand (rigid rack) to the safety stand (rigid rack) installation position for the left rear wheel.
scientia non olet · About LEMON Manuals