LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (On-Board Diagnostic - MAZDA Connect (1 Of 5)) >> Diagnostic Assist Function [Connectivity Master Unit (Us)] >> Functional Inspection/Adjustment Menu >> HD recognition information verification

HD recognition information verification

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
  1. Launch the diagnostic assist function. (See ACTIVATION PROCEDURE .)
  2. Select in the following order from the diagnostic assist function initial screen.
    1. [Functional Inspection/Adjustment]
    2. [HD Recognition]
  3. Verify the following information.

    -: Not applicable

    DIAGNOSTIC ASSIST FUNCTION INITIAL SCREEN

    Indication on center display Unit Content/function
    CN dB Indicates the CN ratio.
    P1BER -
    • [M]: Indicates the main tuner P1 bit error rate.
    • [S]: Indicates the sub-tuner P1 bit error rate.
    P2BER -
    • [M]: Indicates the main tuner P2 bit error rate.
    • [S]: Indicates the sub-tuner P2 bit error rate.
    P3BER -
    • [M]: Indicates the main tuner P3 bit error rate.
    • [S]: Indicates the sub-tuner P3 bit error rate.
    P4BER -
    • [M]: Indicates the main tuner P4 bit error rate.
    • [S]: Indicates the sub-tuner P4 bit error rate.
    PIDBLK - Indicates the PIDS block bit error rate.
    Baseband Processor Ver - Indicates the baseband processor version.
    HDACQ - Indicates the HDACQ value.
    DAACQ - Indicates the DAACQ value.
    Error Rate Reset - Resets the error.
  4. Ends the diagnostic assist function. (See ENDING PROCEDURE .)
scientia non olet · About LEMON Manuals