Seat Weight Sensor Inspection (Us/CANADA)
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS.
- Removal of the passenger-side seat
- Loosening and retightening of passenger's seat fixing bolts
- Or, the vehicle is involved in a collision
- If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS. (See SEAT WEIGHT SENSOR CALIBRATION (US/CANADA) .)
- Replacement with a new seat weight sensor
- Replacement with a new seat weight sensor control module
- Replacement with new passenger-side seat parts
- Disassembly of the passenger-side seat
NOTE:
- The SWS calibration can be performed using the M-MDS. For details regarding the procedure, follow the instructions indicated on the M-MDS.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Perform the SWS calibration on the M-MDS screen.