Seat Weight Sensor Calibration (Us/CANADA)

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Special Service Tool (SST)

MT04-S1-001-4
SEAT SENSOR CALIBRATION WEIGHT SET

Courtesy of MAZDA MOTORS CORP.

CAUTION:

If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS.
- Replacement with a new seat weight sensor
- Replacement with a new seat weight sensor control module
- Replacement with new passenger-side seat parts
- Disassembly of the passenger-side seat
If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. (See SEAT WEIGHT SENSOR INSPECTION (US/CANADA) .)
- Removal of the passenger-side seat
- Loosening and retightening of passenger's seat fixing bolts
- Or, the vehicle is involved in a collision

NOTE:

The seat weight sensor calibration can be performed using the M-MDS. For details, follow the instructions displayed on the M-MDS.

Have four 10 kg (22 lb) weights from SST MT04-S1-001-4 ready to use.
Connect the M-MDS.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
1. [Toolbox]
2. [Work Support]
3. [RESTRAINTS]
4. [Calibrating Weight OCS for Air bag]
Perform seat weight sensor calibration following the instructions on the screen.