LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Interior Trim) >> Tire House Trim Removal/Installation

Tire House Trim Removal/Installation

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  2. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
    3. Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
    4. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    5. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    6. Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION .)
  3. Partially peel back the seaming welt.
    G13560812Courtesy of MAZDA MOTORS CORP.
  4. Move the tire house trim in the order of arrows (1), (2) shown in the illustration, and remove it while detaching clips and tabs.
    G13560813Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals