C-Pillar Trim Removal/Installation

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Replacement part

Clip D

Quantity: 1

Location use: C-pillar trim

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
Remove the trunk side upper trim. (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
Partially peel back the seaming welt.

Courtesy of MAZDA MOTORS CORP.
Partially peel back the weatherstrip.
Disconnect the connector. (with Bose®)
Pull the C-pillar trim in the direction of the arrow in the order of (1), (2) while detaching clip A, clips B, clips C and clips D.

Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.
NOTE:
- When replacing the C-pillar trim, remove the rear side speaker. (See REAR SPEAKER REMOVAL/INSTALLATION .)
- When replacing the C-pillar trim, remove the rear speaker grille. (See SPEAKER GRILLE REMOVAL/INSTALLATION .)