Repeatability Verification Procedure

Set the remaining fuel quantity in the fuel tank between 30-85 %.
Verify that OBD-II information (such as FREEZE FRAME DATA) has been obtained and recorded.
Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))] .)
Start the engine and switch the ignition off after 5 s have elapsed.
Leave the vehicle for 6 hours or more.
Start the engine and leave it idling for 2 min.
Drive the vehicle for 30 min at a speed of 50 km/h {31 mph} or more (to increase temperature in fuel tank and generate evaporative gas).
NOTE:
- If driving the vehicle for 30 min at a speed of 50 km/h {31 mph} or more is not feasible, the vehicle can be driven for a continuous 15 min or more with the engine coolant temperature at 80 °C {176 °F} or more.
Stop the engine.
Leave the vehicle for 1 hours or more.