LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Transfer Oil Seal Replacement >> Transfer oil seal (RH) No. 2

Transfer oil seal (RH) No. 2

WARNING: This page is about a different variant/trim than selected.
  1. Drain the transfer oil. (See TRANSFER OIL REPLACEMENT .)
  2. Remove the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
  3. Remove the transfer oil seal (RH) No. 1. (See Transfer oil seal (RH) No. 1 )
  4. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (RH) No. 2 as shown in the figure and remove the oil seal (RH) No. 2.
    Fig 1: Inserting Tape-Wrapped Flathead Screwdriver Into Lip Area Of Oil Seal (RH) No. 2
    G09075112Courtesy of MAZDA MOTORS CORP.
  5. Using the SST and a hammer, tap the new seal into place.
    Fig 2: Tapping Seal Into Place Using SST
    G11427300Courtesy of MAZDA MOTORS CORP.
  6. Apply the lip of the oil seal with transfer oil.
  7. Install the transfer oil seal (RH) No. 1. (See Transfer oil seal (RH) No. 1 .)
  8. Install the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
  9. Add the specified amount and type of oil. (See TRANSFER OIL REPLACEMENT .)
scientia non olet · About LEMON Manuals