Diagnostic Procedure
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM DTC INSPECTION FOR REAR BODY CONTROL MODULE (RBCM)
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [REAR BODY CONTROL MODULE (RBCM)] .) Then go to Step 5. |
| No | Go to the next step. | ||
| 2 | INSPECT BRAKE SWITCH
|
Yes | Go to the next step. |
| No | Replace the brake switch, then go to the Step 5. (See BRAKE PEDAL REMOVAL/INSTALLATION .) |
||
| 3 | PERFORM DTC INSPECTION FOR INSTRUMENT CLUSTER
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) Then go to Step 5. |
| No | Go to the next step. | ||
| 4 | PERFORM DTC INSPECTION FOR RADAR UNIT
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [RADAR UNIT] .) Then go to the next step. |
| No | Go to the next step. | ||
| 5 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 6 | VERIFY THAT NO OTHER DTCs ARE PRESENT
|
Yes | Perform the corresponding DTC inspection. |
| No | DTC troubleshooting completed. | ||