LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (On-Board Diagnostic - Blind Spot Monitoring Control Module) >> DTC U3000-97; Radar Performance Malfunction >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

Step Inspection Action
1 INSPECT REAR BUMPER SURFACE
  • Visually inspect the rear bumper surface for the following:
    • Dirt
      • Adhered foreign material (reflective object)
  • Is the rear bumper normal?
 Yes Go to the next step.
No Remove dirt or foreign material (reflective object), then go to Step 4.
2 INSPECT AREA AROUND BLIND SPOT MONITORING (BSM) CONTROL MODULE
  • Visually inspect the area around the blind spot monitoring (BSM) control module for the following:
    • Dirt
      • Adhered foreign material(reflective object)
  • Is the area around the blind spot monitoring (BSM) control module normal?
 Yes Go to the next step.
No Remove dirt or foreign material (reflective object), then go to Step 4.
3 VERIFY REAR BUMPER REPAIR HISTORY
  • Verify if the rear bumper had been repaired or repainted before.
  • Is the paint Mazda genuine?
 Yes Go to the next step.
No Replace the rear bumper, then go to the next step.
(See REAR BUMPER REMOVAL/INSTALLATION .)
4 VERIFY THAT REPAIRS HAVE BEEN COMPLETED Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
5 VERIFY IF OTHER DTCs DISPLAYED
  • Are any other DTCs displayed?
 Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals