LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (On-Board Diagnostic - Dynamic Stability Control (DSC)) >> DTC C0001-01; C0002-01; C0003-01; C0004-01; C0010-01; C0011-01; C0014-01; C0015-01; C0018-01; C0019-01; C001C-01; C001D-01; Control Solenoid Valve Systems >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY SOLENOID VALVE OPERATION
  • Switch the ignition to off.
  • Connect the M-MDS to the DLC-2.
  • Switch the ignition ON (engine off).
  • Access the active command mode for the solenoid valve using the M-MDS. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
  • Does the solenoid valve operate?
 Yes Go to the next step.
No Replace the DSC HU/CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION .)
2 VERIFY DTC TROUBLESHOOTING COMPLETED Yes Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION .)
No Go to the next step.
3 VERIFY AFTER REPAIR PROCEDURE
  • Are any other DTCs present?
 Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals