LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (On-Board Diagnostic - Engine Control (2 Of 5)) >> DTC P0087; Pcm Fuel Pressure Sensor Circuit Range/Performance Problem >> Troubleshooting Diagnostic Procedure >> Intention of troubleshooting procedure

Intention of troubleshooting procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION RESULTS ACTION
1 PURPOSE: VERIFY IF MALFUNCTION RELATED TO FUEL SYSTEM PIPES (LOW PRESSURE SIDE) AFFECTS DIAGNOSTIC RESULTS Yes Replace the fuel pump unit, then go to Step 3.
(See FUEL PUMP UNIT REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Inspect the fuel system pipes (low to high pressure sides) for fuel leakage and restriction.
  • If there is any malfunction:
    • Repair or replace the malfunctioning part according to the inspection results, then go to Step 3.
  • If there is no malfunction:
    • Go to the next step.
2 PURPOSE: DETERMINE INTEGRITY OF FUEL PRESSURE SENSOR Yes Replace the fuel distributor, then go to the next step.
(See FUEL INJECTOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Go to the next step.
3 PURPOSE: VERIFICATION OF VEHICLE REPAIR COMPLETION Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
4 PURPOSE: VERIFY IF THERE IS ANY OTHER MALFUNCTION
  • Is any other DTC or pending code stored?
Yes Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .)
No DTC troubleshooting completed.