LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Security And Locks) >> Request Switch Inspection >> Driver's Door/Passenger's Door

Driver's Door/Passenger's Door

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the front door glass preparation. (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Remove the following parts:
    1. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    2. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
    3. Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    4. Front door key cylinder (driver's side) (See FRONT DOOR KEY CYLINDER REMOVAL/INSTALLATION .)
    5. Front outer handle (See FRONT OUTER HANDLE REMOVAL/INSTALLATION .)
  4. Verify that the continuity is as indicated in the table.
    Fig 1: Request Switch Continuity Reference Chart
    G11273570Courtesy of MAZDA MOTORS CORP.
    Fig 2: Inspecting Request Switch
    G11467813Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the front outer handle.
scientia non olet · About LEMON Manuals