LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Entertainment System >> Rear Speaker Inspection

Rear Speaker Inspection

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    2. Bass-box (With Bose ®) (See BASS-BOX REMOVAL/INSTALLATION .)
    3. Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    5. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    6. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
    7. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    8. Rear speaker (See REAR SPEAKER REMOVAL/INSTALLATION .)
  3. Verify that the resistance between the front center speaker terminals is as indicated in the table.
    Fig 1: Checking Resistance Between Front Center Speaker Terminals
    G09077668Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the rear speaker.
    Fig 2: Front Center Speaker Terminals Resistance Chart
    G11426101Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals