GPS Antenna Feeder Inspection

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
2. Upper decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
3. Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
4. Meter hood No. 1 (See METER HOOD REMOVAL/INSTALLATION .)
5. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
6. GPS antenna (See GLOBAL POSITIONING SYSTEM (GPS) ANTENNA REMOVAL/INSTALLATION .)
7. Center display component (See CENTER DISPLAY REMOVAL/INSTALLATION .)
Disconnect the GPS antenna connector. (See GLOBAL POSITIONING SYSTEM (GPS) ANTENNA REMOVAL/INSTALLATION .)
Verify that the continuity is as indicated in the table.

Fig 1: Global Positioning System Antenna Terminal Chart (1 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 2: Global Positioning System Antenna Terminal Chart (2 Of 2)
Courtesy of MAZDA MOTORS CORP.
- If not as indicated in the table, replace GPS antenna feeder.