Diagnostic Procedure

Step	Inspection		Action
1	VERIFY RADAR UNIT DTCs Retrieve the radar unit DTCs using the M-MDS. (Refer to DTC INSPECTION [RADAR UNIT] .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (Refer to DTC TABLE [RADAR UNIT] .)
1		No	Go to the next step.
2	VERIFY IF MALFUNCTIONING LOCATION IS RADAR UNIT DEPENDING ON REPEATABILITY Clear the DTC for the instrument cluster using the M-MDS. (Refer to CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition ON (engine off or on) and wait for 20 s or more . Retrieve the instrument cluster DTCs using the M-MDS. (Refer to DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC displayed?	Yes	Replace the radar unit, then go to the next step. (Refer to RADAR UNIT REMOVAL/INSTALLATION .)
2		No	Go to Step 4.
3	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the instrument cluster using the M-MDS. (Refer to CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition ON (engine off or on) and wait for 20 s or more . Retrieve the instrument cluster DTCs using the M-MDS. (Refer to DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the instrument cluster. (Refer to INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) Go to the next step.
3		No	Go to the next step.
4	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (Refer to DTC TABLE [INSTRUMENT CLUSTER] .)
4		No	DTC troubleshooting completed.