Resistance Inspection
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
- Disconnect the fuel injector connector.
- Inspect the resistance between fuel injector terminals A and B.
Fuel injector resistance
- 11.4-12.6 ohms [20 °C {68 °F}]
- If not within the specification, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION .)