Charging System Warning Light

Verify that the battery is fully charged.
Verify that the drive belt is correct. (See DRIVE BELT INSPECTION [MZR 2.5] .)
Switch the ignition to ON, verify that the charging system warning light illuminates.
- If it does not illuminate, inspect the charging system warning light and the wiring harness.
  1. If the charging system warning light and the wiring harness are normal, inspect the PCM.
Verify that the charging system warning light goes out after the engine is started.
- If the charging system warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) (See DTC TABLE [MZR 2.5] .)