Diagnostic Procedure

Step	Inspection		Action
1	PERFORM BSM CONTROL MODULE DTC INSPECTION Perform the BSM control module DTC inspection using the M-MDS. (See DTC INSPECTION [BLIND SPOT MONITORING (BSM)] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [BLIND SPOT MONITORING (BSM)] .)
1		No	Go to the next step.
2	PERFORM INSTRUMENT CLUSTER DTC INSPECTION Clear the DTC from the instrument cluster memory using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the BSM control module (LH), then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the instrument cluster memory using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCs ARE RECORDED Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .)
4		No	DTC troubleshooting completed.