Diagnostic Procedure

Step	Inspection		Action
1	PERFORM KEYLESS CONTROL MODULE DTC INSPECTION Perform the keyless control module DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
1		No	Go to the next step.
2	PERFORM INSTRUMENT CLUSTER DTC INSPECTION Clear the DTC from the instrument cluster memory using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the instrument cluster memory using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCs ARE RECORDED Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .)
4		No	DTC troubleshooting completed.