Resistance Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI 3.7 V6] .)
- Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
- Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
- Disconnect the fuel injector connectors.
- Measure the resistance of the fuel injector.
Fuel injector resistance
- 11.3-12.7 ohms [20 °C {68 °F}]
- If not as specified, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION .)