Oil Filter Replacement
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
- A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
- Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
CAUTION:
- If engine oil is spilled on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.
- Remove the oil filter using a oil filter wrench.
- Use a clean rag to wipe off the mounting surface on the oil filter adapter and the oil filter.
- Apply clean engine oil to the O-ring of a new oil filter.
- Install the oil filter until the O-ring contacts the sealing surface.
- Tighten the oil filter 3/4 turns by hand.
- Start the engine and confirm that there is no oil leakage.
- If there is oil leakage, repair or replace the applicable part.
- Inspect the oil level. (See ENGINE OIL LEVEL INSPECTION .)