LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (On-Board Diagnostic [Engine Controls MZI 3.7] (4 Of 5)) >> DTC P0562:00 >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related Service Bulletins available?
 Yes Perform repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 INSPECT THE CHARGING SYSTEM 
 Yes Repair or replace the malfunctioning part according to the inspection results, then go to the next step.
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P0562:00 HAS BEEN COMPLETED 
  • Verify that all disconnected connectors reconnected.
  • Clear the DTC from the PCM memory using the M-MDS.

    (See AFTER REPAIR PROCEDURE .)

  • Start the engine and run it at idle.
  • Perform the KOEO or KOER self-test.

    (See KOEO/KOER SELF TEST .)

  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals