Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP	INSPECTION		ACTION
1	INSPECT SELECTOR LEVER AND SELECTOR CABLE ADJUSTMENT FOR MALFUNCTION Does the vehicle creep when selector lever is moved slightly in N position?	Yes	Go to the next step.
1		No	Inspect and adjust the selector lever and cable. (See SELECTOR LEVER INSPECTION .) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .) Perform N position learning. (See TCM REMOVAL/INSTALLATION .)
2	INSPECT IF MALFUNCTION CAUSE IS SHIFT SOLENOIDS OR TRANSAXLE Inspect following solenoid. Shift solenoid C (See SHIFT SOLENOID C INSPECTION .) Shift solenoid D (See SHIFT SOLENOID D INSPECTION .) Are these solenoids normal?	Yes	Replace the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
2		No	Inspect the coupler component. If normal, replace the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION .)
3	Verify test results. If normal, return to the diagnostic index to service any additional symptoms. If malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis. If the vehicle is repaired, troubleshooting completed. If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.