LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Symptom Troubleshooting [Automatic Transaxle AY6A-El]) >> No.1 Vehicle Does Not Move In D Or In R Position >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
STEP INSPECTION ACTION
1 INSPECT PARKING MECHANISM FOR MALFUNCTION 
  • When the vehicle is stopped on a flat, level road and the engine off, does the vehicle move when pushed? (in D or N, R positions with the brake pedal released)
Yes Go to the next step.
No Inspect for parking mechanism.
2 INSPECT SELECTOR LEVER AND SELECTOR CABLE ADJUSTMENT FOR MALFUNCTION 
  • Start the engine.
  • Does vehicle move when selector lever in between N position and D position?
Yes Inspect or adjust selector lever and cable.
(See SELECTOR LEVER INSPECTION .)
(See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
Perform N position learning.
(See TCM NEUTRAL POSITION LEARNING .)
No Go to the next step.
3 INSPECT SHIFT SOLENOIDS FOR MALFUNCTION 
Yes Go to the next step.
No Inspect the coupler component.
If normal, replace the control valve body.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION .)
4 VERIFY IF MALFUNCTION CAUSE IS TORQUE CONVERTER OR TRANSAXLE 
Yes Replace the transaxle.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
No Replace the torque converter.
(See TORQUE CONVERTER REMOVAL/INSTALLATION .)
5
  • Verify test results.
    • If normal, return to the diagnostic index to service any additional symptoms.
    • If malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
      • If the vehicle is repaired, troubleshooting completed.
      • If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.